Gima SUPER VEGA 36 Bedienungsanleitung Seite 19

Filter assembling
Suction Pump
Inlet
WARNING: The power supply cable plug is the element of separation from the electrical mains system: even if the units equipped
with a special on / off switch button, the power supply plug must be kept accessible once the device is in use so as to allow a
further method of disconnection from the mains supply system.
Operation using cigarette lighter DC 12V

Connect the device's external plug 12V to the ligther plug with the cigarette lighter cable. Check the battery power status of
the vehicle before the cigarette lighter cable. Press the switch to start suction

Press the switch to the I position to turn it on.
WARNING: Only use the originally supplied or recommended replacement cigarette ligther cables (view the chapter
"Important Safety Rules")
WARNING: Before using the device, check the battery power status. Before each use proceed with charging the
battery. To maintain the device in good conditions, recharge the battery every 3 months (when not in use).
Recharging operations: to be able to charge the internal battery it is necessary to connect the universal switching adapter
(mod. UE 60140429SPA1 of FUHUA) to the electric network for approx. 240 minutes with the main switch to position 0.
The battery's autonomy when fully charged is approx. 60 minutes with continued operations.
TAB. I – INDICATOR LIGHTS DURING OPERATIONS
When an external power supply (regardless of the state of the battery charger) and when the device is working (after having
turned it on), the LED stays in a FIXED GREEN position.
LED Signal
Flashing Green Led
Steady Greed Led
Steady Red Led
Flashing Red Led
Steady Orange Led
FLOW DIRECTION
Phase
During rechanrge
During recharge
During battery operation
Device automatically turns
off when the battery is flat
During battery operation
IN / Fluid Inside
IN
Problem / Cause
Battery recharge running
Recharging cycle complete
Flat battery
Battery completely flat
Intermediate status
20
GB
Jar Air Tube
Solution
Wait
Remove power supply
Start recharging cycle
WARNING: During this
signal, you will hear a long,
continuous beep (duration of
sound 0.8 sec / sound
frequency: every 8.5 sec,
which notifies the user
regarding the battery
discharge.
When the device is restarted
the LED will flash red: begin
the battery recharge cycle
immediately
Guaranteed battery function
/ Recharge when the red LED
signal comes on.