Data Cabling; Cable Connectors; Control Panel - afx light SPOT100-LED Bedienungsanleitung

DATA CABLING

To link fixtures together you must use data cables. If you choose to create your own cable, please
use data-grade cables that can carry a high quality signal and are less prone to electromagnetic
interference.

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female
XLR connector on the other end.
Termination reduces signal errors. To avoid signal transmission
problems and interference, it is always advisable to connect a DMX
signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chas-
sis ground. Grounding the common can cause a ground loop, and
your fixture may perform erratically. Test cables with an ohm meter to check correct polarity and
to make sure the pins are not grounded or shorted to the shield or each other.
DESCRIPTION OF THE REAR PANEL
1 2 3 4
DMX IN DMX OUT POWER IN POWER OUT
1. DMX IN: Connect a DMX cable from the DMX output connector of a DMX controller to this DMX
input
2. DMX OUT: Connect this output to the DMX input connector of a slave unit
3. POWER IN: Connect the supplied mains lead to this connector and to an appropriate wall outlet.
4. POWER OUT: Connect this power output to the POWER IN connector of a slave unit
5. ON/OFF switch of the unit
6. 3A fuse

CONTROL PANEL

The control panel is the mechanism for configuring the settings. It has an LCD screen and buttons,
which are described below.
1. DMX: lights up when the unit is in DMX mode and receives a DMX signal
2. Error: lights up when a default is detected
3. LCD screen showing the current settings
4. <◀ ▶>: Scrolls through the first level of options, or exits from the current menu or function
<▲>: Navigates upward through the menu list or increases the numeric value when in a function
<>: Navigates downward through the menu list or decreases the numeric value when in a func-
tion
<OK>: Enables the currently displayed menu or sets the currently selected value in to the current
function
EN 4
5
6
1
DMX
SPOT100-LED
ERR
2
LCD DISPLAY
3
4
OK
© Copyright LOTRONIC 2019