Herunterladen Inhalt Inhalt Diese Seite drucken

Disconnect Device; Dmx Connection; Data Cabling; Cable Connectors - afx light BARLED200-FX Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The appliance must be replaced if it is damaged or thermally deformed.
• The LED protection screen must be replaced if it is visibly damaged to the point of impairing its
effectiveness, for example due to cracks or deep scratches.
• The light source of this luminaire is not replaceable; when the light source reaches the end of its
life, the entire luminaire must be replaced.

DISCONNECT DEVICE

Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope.
Never stand directly below the device when mounting, removing or servicing the fixture.

DMX CONNECTION

Connect an XLR cable to the male 3-pin XLR output of your controller and the other side to the fe-
male 3-pin XLR input of the light.You can chain multiple lights together through serial linking
The cable needed should be two core, screened cable with XLR input and output connectors.

DATA CABLING

To link fixtures together you must use data cables. If you choose to create your own cable, please
use data-grade cables that can carry a high quality signal and are less prone to electromagnetic
interference.

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female
XLR connector on the other end.
Termination reduces signal errors. To avoid signal transmission
problems and interference, it is always advisable to connect a DMX
signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chas-
sis ground. Grounding the common can cause a ground loop, and
your fixture may perform erratically. Test cables with an ohm meter to check correct polarity and
to make sure the pins are not grounded or shorted to the shield or each other.
DESCRIPTION OF THE REAR PANEL
1
2
POWER IN
DMX IN
3 4
8.8.8.8.
MIC
MENU
UP
DOWN ENTER
www.afx-light.com
5
6
7
DMX OUT
POWER OUT
SAFETY HOOK
3
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis