Inhaltsverzeichnis
Werbung
Electrical connection
Do not use any extension cables or distributors.
The socket to which the appliance is connected
must be easily accessible. Connect the appliance
to 220 240 V/50 Hz alternating current via a correctly
installed earthed socket. The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated in a non European
country, check on the rating plate whether the
indicated voltage and current type correspond to
the values of your mains supply. The rating plate
is situated in the bottom left hand side of the
appliance. The power cord may be replaced by
an electrician only.
!
Warning
Never connect the appliance to electronic energy
saver plugs or to power inverters which convert
the direct current to 230 V alternating current
(e.g. solar equipment, power supplies on ships).
Factory settings
Upon leaving the factory, the appliance has been
supplied with the following settings:
-
Fascia language:
-
Temperature unit:
Refrigeration zone temperature +4 °C
-
Note
The factory settings (language, temperature unit)
can be changed in the setup mode.
30
Switching on the appliance
D
The appliance starts to cool down when switched on for
the first time. When the door is opened, the interior light
comes on.
Note
The preset temperatures (factory settings) are reached
after approx. 2-8 hours. Do not put any food in the
appliance beforehand.
To change the set temperatures > see Setting the
temperature".
Selecting the temperature
The temperature can be set from +2 °C to +8 °C.
We recommend a setting of +4 °C.
The temperature setting can be changed using the
+ (warmer) or (cooler) setting buttons. The temperature
English
can be set at 1 °C intervals.
°C
To set the temperature:
D
D
O
Press the On/Off button
Active the setup mode using the
The
symbol is displayed.
rs
Set the desired temperature using the + (warmer)
or - (cooler) setting buttons.
.
(
or
)
buttons.
Werbung
Kapitel
Inhaltsverzeichnis
