Inhaltsverzeichnis
Werbung
Safe Operation
Practices
for Snow Throwers
Training
1
Read the operatingand service instruction manual care-
fully. Be thoroughIy familiar with the controls and the
proper use of the equipment Know how to stop the unit
anddisengage the controls quickly
2
Never allow children to operate the equipment
Never
allow adults to operate the equipment without proper
instruction.
3
Keepthe areaofoperation clear of all persons, padicularty
small children, and pets
4
Exercise caution to avoid slipping or falling, especially
when operating in reverse
Preparation
i
Thoroughly inspect the area where the equipment is to
be used and remove alt doormats, sleds, boards, wires
and other foreign objects
2
Disengage all clutches and shift into neutral before start_
ing the engine.
3.
Do not operate the equipment without wearing adequate
wintergarments Wearfootwearwhich witl improvefooting
on slippery surfaces.
4.
Handle fuet with care; it is highly flammable
a) Use an approved fuel container
b) Never add fuel to a running or hot engine
c) Fil! fuel tank outdoors with extreme care
Never fill fuel tank indoors
d) Replace gasotinecaps securely and wipe up spilted fuet
5.
Use a grounded three-wire plug-in for all units with electric
drive motors or electric starting motors..
6.
Adjust the collector housing height to clear gravel or
crushed rock surface
7
Never attempt to make any adjustments while the engine
is running (except where specifically recommended by
manufacturer)
8.
Let engine and machine adjust to outdoor temperatures
before starting to clear snow
9
The operation of any powered machine can result in
foreign objects being thrown into the eyes. Always wear
safety glasses or eye shields during operation or while
performing an adjustment or repair.
Operation
t
Do not put hands or feet near or under rotating parts
Keep clear of the discharge opening at all times.
2
Exercise extreme caution when operating on or cross-
ing gravel drives, walks, or roads Stay alert for hidden
hazards or traffic
3
After striking a foreign object, stop the engine, remove
the wire from the spark plug, thoroughly inspect the snow
thrower for any damage and repair the damage before
restarting and operating the snow thrower
4.
If the unit should start to vibrate abnormally, stop the
engine and check immediately for the cause Vibration
is generally a warning of trouble
5.
Stop the engine whenever you leave the operating posi-
tion, before unclogging the collector/impeller housing or
discharge guide and when making any repairs, adjust-
ments or inspections
6
When cleaning, repairing, or inspecting make certain the
collector/impeller and all moving parts have stopped
Disconnect the spark plug wire, and keep the wire away
from the plug to prevent accidental starting Disconnect
the cable on electric motors
7
Do not run the engine indoors, except when starting it-
and for moving the snow thrower in or out of the building
Open the outside doors; exhaust fumes are dangerous 3
8
Do not clear snow across the face of slopes Exercise
extreme caution when changing direction on slopes Do
not attempt to clear steep slopes
9
Never operate the snow thrower without proper guards,
plates or other safety protective devices in place
I0
Never operate the snow thrower near glass enclosures,
automobiles, windowwells, drop-offs, etc without proper
adjustment of the snow discharge angle Keep children
and pets away.
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
11
t2
13
!4
t5
Never operate the machine at high transport speeds on
slippery surfaces. Use care when reversing
Never direct discharge at bystanders or allow anyone in
front of the unit
Disengage power to the collector/impeller when snow
thrower is transported or not in use
Use only attachments and accessories approved by the
manufacturer of the snow thrower (such as wheel weights,
counterweights, cabs, etc.)
16 Never operate the snow thrower without good visibility
or light, Always be sure of your footing, and keep a firm
hold on the handles Walk; never run
Maintenance
and Storage
1
Check shear bolts, engine mounting bolls, etc, at frequent
intervals for proper tightness to be sure the equipment is
in safe working condition
2
Never store the machine with fuel in the fuel tank inside
a building where ignition sources are present such as hot
water and space heaters, clothes dryers, etc Allow the
engine to cool before storing in any enclosure
3
Always refer to owner's guide inslructions for important
details if the snow thrower is to be stored for an extended
period
4
Maintain or replace safety and instructions labels, as
necessary
5
Run the machine a few minutes after throwing snow to
prevent freeze-up of the collector/impeller
Sichere
Bedienung
fri se
Vorkenntnisse
1
einer
Schnee-
Lesen Sie die Bedienungs-
und Wartungsanfeitung
sorgf&ftig. Machen Sie sich sorgf<igst mit den Steuer-
elementen
und dem sachgem&Ben Gebrauch
des
Ger&tes vertraut
Eignen Sie sich die F&higkeit an, das
Ger#.t schnell stoppen und die Steuerelemente schnell
abschaften zu kSnnen
2
Kindem darfdie Bedienung desGer&tes unter keinen Um-
st&nden gestattet werden. Bedienung des Ger&tes durch
Erwachsene, die nicht sachgem&B eingewiesen wurden,
darf unter keinen Umst&nden gestattet werden
3
Hatten Sie den Verwendungsbereich frei yon jeglichen
Personen, insbesondere yon kleinen Kindem, und yon
Haustieren.
Gehen Sie vor atlem be! der Bedienung im Reckw_rts-
gang vorsichtig vor, um Ausrutschen oder Hinfallen zu
vermeiden
Vorbereitung
1
lnspizieren Sie sorgf<ig den Bereich, in dem das Ger_t
verwendet werden soil, und entfemen Sie alleTi3rverteger,
Schlitten, Bretter, Dr&hte u a FremdkSrper
2
Kuppeln Sie voltst&ndig aus und schalten Sie in den
Leerlauf, bevor Sie den Motor anlassen
3
Bedienen Sie das Ger&t nicht ohne ad&quate Winter-
bekleidung Tragen Sie Schuhe, die einen sicheren Stand
auf rutschigem Boden beg0nstigen
Werbung
Inhaltsverzeichnis
