Cleaning The Hob; Fault - Angelo Po 04WVT3RV Bedien- Und Installationshandbuch

CLEANING THE HOB

To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Clean the hob thoroughly with a sponge and
normal detergents, rinse with plenty of water
and dry.
TROUBLESHOOTING
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.

Fault

The plates do not turn on
The plates do not turn off
Important
Do not spray water onto the plates when
still hot as this can damage them.
FAULT
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Cause
Electrical connection not
made correctly
Power regulator failure
Component fault
- 11 -
IDM-39612800700.tif
Remedy
Check the connection of the
electrical wires
Important
Contact the after-sales service
Replace regulator.
Important
Contact the after-sales service
Important
Contact the after-sales service
6
IT
GB
DE
FR
ES
English