To charge the product via the charging station, plug the male connector of the mains adaptor
the female connector (charging station)
charge the product (see Fig. B).
Note: The product is fitted with an overcharge protection circuit. Despite this, you should disconnect
the LED inspection lamp from the power supply after the charging process is complete.
Note: During charging, the charging indicator (LED work light)
complete, the charging indicator (LED work light)
(LED work light)
3
adaptor
from the product to prevent the rechargeable battery from discharging.
10
Use
Q
CAUTION – RISK OF ACCIDENT! Always store and secure the product in such a way that
there is no risk of injury from or damage to the product, even during full braking.
Note: The product features magnets
isable to carry the weight of the product, before you use the magnets
U sing the product without a power connection
F ully charge the product as described in the section "Charging the product".
Press the ON / OFF switch
P ress the ON / OFF switch
at the same time.
Press the ON / OFF switch
Corded use of the product
U se the included mains adaptor
the product to a suitable power supply.
T hen proceed as described under „Using the product without a power connection" (starting with step 2).
NOTE: The product can only be charged whilst off!
Fixing the product
Q
The product can be used in 2 ways without having to hold it in your hand:
H old the magnets
F old out the hook
turned through 360 degree.
M ounting the charging station (see Fig. C)
Note: You will need an electric drill.
18 GB/IE
9
is green, pull the mains adaptor
on the back. Ensure the metallic surface is sufficiently magnet-
6
to turn the inspection light
4
again to turn the torch
4
the third time, the entire product will be switched off.
4
for this purpose. Using the respective mains adaptor
10
against a metallic magnetic surface. The product remains in this position.
6
to suspend the product from a suitable suspension point. The hook
5
. Then place the product into the charging station to
3
lights up green. When the charging indicator
3
out of the socket. Disconnect the mains
10
on.
2
on and the inspection light
1
lights up red. When charging is
.
6
will turn off
2
10
into
10
, connect
can be
5