Starting And Stopping; Check Before Starting - McCulloch B40 P ELITE Bedienungsanweisung

S1154653-38,B40 B,P ELITE_1.fm Page 17 Wednesday, March 14, 2012 7:51 AM

Check before starting

• Check the blade to ensure that no cracks have formed
at the bottom of the teeth or by the centre hole. The
most common reason why cracks are formed is that
sharp corners have been formed at the bottom of the
teeth while sharpening or that the blade has been
used with dull teeth. Discard a blade if cracks are
found.
• Check that the support flange is not cracked due to
fatigue or due to being tightened too much. Discard
the support flange if it is cracked.
• Ensure the locking nut has not lost its captive force.
The nut lock should have a locking force of at least 1.5
Nm. The tightening torque of the locking nut should be
35-50 Nm.
• Check that the blade guard is not damaged or
cracked. Replace the blade guard if it is exposed to
impact or is cracked.
• Check that the trimmer head and trimmer guard are
not damaged or cracked. Replace the trimmer head or

STARTING AND STOPPING

•
•
Starting and stopping
Starting
Ignition: Set the stop switch to the start position.
Choke:
Set the choke control in the choke position.
trimmer guard if they have been exposed to impact or
are cracked.
Never use the machine without a guard nor with a
defective guard.
All covers must be correctly fitted and undamaged
before you start the machine.
WARNING! The complete clutch cover
!
and shaft must be fitted before the
machine is started, otherwise the clutch
can come loose and cause personal
injury.
Always move the machine away from the
refuelling area and source before
starting. Place the machine on a flat
surface. Ensure the cutting attachment
cannot come into contact with any
object.
Make sure no unauthorised persons are
in the working area. Otherwise there is a
risk of serious personal injury. The safety
distance is 15 metres.
–
English 17