Bezzera ELLISSE series Bedienungsanleitung Seite 38

BEZZERA ELLISSE
MOD.
Problem
The flow of coffee is excessive
The coffee supplied is too cold
The coffee supplied is warm
The coffee supplied is too hot
Diagnostics/Solution
The coffee is supplied too
quickly and the cream is lighter
than usual.
Possible causes:
1 – The grinding of coffee is too
coarse.
2 – The coffee in the filter hold- The coffee in the filter hold- The coffee in the filter hold-
er has not been pressed
enough.
3 – The dose in the filter holder
is scarce.
4 – The pressure supplied by the
pump is high (> 10 bar – 1
MPa).
Possible causes:
1 – The cups are cold.
2 – The filter holders are cold.
3 – The grinding of the coffee is
too thin.
4 – The machine's water circuit
is dirty (limestone).
5 – The boiler's pressure is low- The boiler's pressure is low- The boiler's pressure is low-
er than 0.8 bar (0.08 MPa).
The coffee supplied is warm if
the pressure is normal, between
1 and 1.2 bar (0.1 – 0.12 MPa).
In this case, the pressure value
is not correct.
Possible causes:
1 – The boiler's pressure is
higher than 1.3 bar (0.13
MPa).
2 – The machine is covered by
something that
cooling.
3 – The machine was installed
in a position that does not
allow air circulation
38
In cases 1-2-3 adjust grinding
and/or dosing of coffee.
In the 4th case, a technician
must be consulted.
In the 1st case, use the cup
warmers.
In the 2nd case, keep the fil-
ter holder assembled on the
group.
In the 3rd case, adjust the grind-
ing of the coffee.
In cases 4-5, call a specialized
technician.
Call a specialized technician to
check the exhaust valve. Mean-
while, to use the machine, open
the steam tap (Fig. 01; pos 3
– 07); the boiler's pressure will
drop to zero, thus causing the
enabling of the resistor and the
increase of temperature. Per-
form this operation daily when
turning on the machine.
In the 1st case, call a special-
ized technician.
In cases 2-3 reset the machine's
cooling conditions.
prevents
Advices