Würth 100 A Originalbetriebsanleitung Seite 22

Start POWER SUPPLY mode
POWER SUPPLY
U=19.6V I<50A
Note
In contrast to the other modes, in
the voltage drop in the cables is not compensated. In
this case, the voltage on the display corresponds to the
output voltage of the device (and not the voltage at
the terminals).
Settings menu
Access to the
Einstellungen
f
3 sec - Settings
MODE
To access the submenus, press the
f
Languages > Restart > Lock Showroom > Check cables >
SELECT
ADVANCED MENU > Reset Memory
Submenu
Languages:
This menu is used to select the languages (using the arrows).
Automatic restart:
The automatic restart function only works in
or mode. In the event of a power failure, this
[Charging] Power Supply
function enables automatic restart of the charger and the automatic
restarting of charging. The "Automatic restart" function, is activated
with "Setting – Restart: ON".
«Lock Showroom»:
For locking mode («Lock button», to prevent misuse).
Showroom
Activate the "Lock Showroom" function with the setting "Einstellung
[Setting] – Lock Showroom: Y".
22
POWER SUPPLY
U=19.6V I=10A
POWER SUPPLY
[Settings] menu item:
button
Select
,
Showroom Ladung
mode,
neustart:
lock showroom:
Short cut for Lock Showroom:
can also be activated without accessing the Einstellun-
Lock Showroom
gen [Settings] menu:
Press the switch.
OFF
f
Press the
Mode
f
Switch the device back on by pressing and holding
f
The display shows
3
Press and hold the
f
Lock Showroom: Y
Settings menu
Nederlands
EINSTELLUNGEN
Deutsch
EINSTELLUNGEN
OFF
Y (yes)
EINSTELLUNGEN
N N (no)
EINSTELLUNGEN
Kabel überprüfen:
START drücken
EINSTELLUNGEN
Advanced menu
Advanced menu:
START drücken
EINSTELLUNGEN
Reset Memory
Reset Memory:
START drücken
switch.
for 3 seconds.
WÜRTH 100 A
switch until:
Mode
is displayed.
English
Francais
Deutsch
Espanol
Portugues
Italiano
Russian
...
ON
OFF
KABEL
ÜBERPRÜFEN
.
Mode