Notes:
#
Do not change the entry under "Username".
#
The camera password cannot be changed under "Password". To change the
camera password, proceed as described in Chapter 12.2.3.
12.5 Delete camera access on the mobile device [42 -Delete]
!
To delete camera access on your mobile device, press the recycle icon [43]
and confirm with "YES".
Note:
Access to the camera will only be deleted on this particular mobile device. If
other mobile devices have access to the camera, access to the camera can be set
up on additional mobile devices as described under 9.2. However, if access to
the camera has been deleted on all mobile devices, access to the camera must
be set up as described under 9.1. if required.
13. Installation
!
Before fixing the camera permanently, test the quality of the connection
and optimise the camera view.
The camera can be wall or ceiling mou
!
First disconnect the camera from the power supply.
!
To install the camera on a wall or ceiling, affix the camera in a suitable spot
using the supplied screws [15] and, where applicable, wall plugs [14].
When mounted on the ceiling the camera's tilt angle may need to be
flipped and the image rotated by 180° (see Chapter 10.1.1 "Flip").
!
Align the camera.
!
R
otate the antenna [ ] so that it points upwards.
1
!
Connect the mains adapter with a suitable mains outlet. The POWER LED
[2] lights red.
14. Reset / loss of camera password
!
To reset the settings and the camera password to the factory settings,
proceed as described in Chapter 12.2.8 "Reset Factory Settings".
!
Alternatively, you can press the reset button [12] on the camera, e.g. with
a straightened paper clip, until the connection LED [6] goes out. Then wait
approximately 30 seconds until it starts to blink. Then proceed as described
in Chapter 9.1 from "Connect camera to mobile device".
15. Maintenance and cleaning
#
The product is maintenance-free: do not open the housing
#
Check the safety and function regularly
#
Remove the mains adapter from the mains socket before cleaning
#
Use a soft, slightly moist cloth or brush to clean the surfaces
16. Disposal
Packaging material or electrical products must not be disposed of as
household waste. Use your recycling system. Details are available
from your local authority.
nted (see fig. B: I and II).
.
17. Declaration of conformity
Indexa GmbH , Paul-Böhringer-Str. 3, D- 74229 Oedheim declares that this
product AC20 complies with the basic requirements and the other relevant
regulations of Directive 1999/5/EC. Conformity has been demonstrated. The
complete declaration of conformity can be read at:
This product can be used in the following countries:
D
A
L
CH
18. Warranty
In addition to the statutory guarantee from the vendor, the manufacturer
warrants this product for 2 years from date of purchase (proof from receipt)
according to following conditions.This warranty does not affect your legal
rights.
The warranty covers use of the product in normal conditions in private
households. It only covers manufacturing defects and is limited to the
replacement or repair of the faulty components. It does not include wear and
tear, or batteries.
The warranty applies only when the product is used according to the operating
instructions. It does not cover damage arising from misuse, improper handling,
application of force, dust, dirt, water or other environmental factors, or from
incorrect voltage from batteries or power supply.
The warranty is void when the product has been repaired or tampered by
unauthorised persons and when it has been used with components which are
not specified by the manufacturer.
In case of a warranty claim please contact the vendor for details of how to
proceed and how to return the product if necessary. Only carriage paid
authorised returns will be accepted. Repairs can only be accepted when
accompanied by a full description of the fault. After the warranty period has
expired repairs will be charged and are not always possible. Warranty claims do
not extend the warranty period and the warranty for replacement parts expires
with the warranty for the product.
Unless there is a statutory obligation, the manufacturer is not responsible for
further claims, including peronal or material damages, arising from the use of
the product or from nonfunction or misfunction of the product.
www.indexa.de.
NL
B
IRL
GB
Indexa GmbH
Paul-Böhringer-Str. 3
74229 Oedheim
www.indexa.de
Germany
GB - 39