Braglia 200.302.77 Handbuch Für Installation, Gebrauch Und Wartung Seite 36

6.3.3 RESETTING TANK
DATA-MATE allows for deletion of information relating to a tank.
Before deleting, you will be prompted to confirm the operation by selecting YES from the dialogue box that appears. Then press
CALIBRAZIONE
Manuale
Automatica
Reset
6.4 – WORK MENU
6.4.1 FILLING
DATA-MATE monitors automatic tank filling in accordance to modes that depend on the available version of DATA-MATE.
6.4.1.1 VERSIONS FITTED WITH LEVEL SENSORS
DATA-MATE will automatically display the litres in the tank, recorded by the level sensor.
LAVORO
Riempimento
Correzione Livello
Azzeramenti
Ampiezza di Lavoro
- Press ;
- Press to enter the amount of liquid you need to pour into the tank, then press
- DATA-MATE will calculate the TARGET value that will be reached after filling has been completed. It will never be possible to exceed the total tank
capacity previously set up;
- Select start and press
- Displayed data will keep flashing until the TARGET volume has been reached;
- The FILLING message will disappear and DATA-MATE will provide an acoustic signal. You can now return to the WORK menu by pressing
at the same time
Filling can be stopped or suspended at any moment by pressing
When DATA-MATE is standing by (FILLING not displayed), you can relocate the WORK menu by pressing
6.4.1.2 VERSIONS WITH A LEVEL SENSOR + FILLING KIT
The filling kit (for instance: flowmeter + pump, flowmeter + valve) must be connected to the AUX B input and to the electronic control equipment.
Operating modes are the same as those described in § 6.4.1.1.
DATA-MATE sends an electronic control signal to automatically stop the pump and shut off the filling kit's valve.
200.1012.15
. Displayed data will start flashing and the message FILLING will appear;
RIEMPIMENTO
Livello 100 l
Target 1000 l
Quantita' 900 l
Start
;
. To resume filling, press
14 / 22
RESET CISTERNA
Reset
Cisterna
SI
FILLING
100
l
1000
l
again.
+ at the same time.
Rev. 01 01/02/2016
.
+