Maintaining The Device; Replacing The Rechargeable Battery; Cleaning And Storage; Troubleshooting - LIVARNO LUX Z31171 Montage-, Bedienungs- Und Sicherheitshinweise

Maintaining the device

Replacing the
rechargeable battery
Note: This work step requires a cross-head screw-
driver and a flat-nose pliers.
Note: Suitable batteries that comply with the
specifications listed under "Technical data" are
available in specialist shops.
Replace the battery
amount of time, the light duration diminishes
noticeably despite good exposure to sunlight.
Only use rechargeable batteries of the right
size and of the recommended type (see section
"Technical data").
Replace the rechargeable battery as indicated
in Figure G.
Slide the AUTO / OFF switch
position.
Use the screwdriver to remove the screws from
the back side of the main station
the front of the main station.
Use the screwdriver to remove the 4 screws of
the 2 fastening brackets and remove the fasten-
ing brackets.
Note: The clamps for the rechargeable batter-
ies are fitted with plug connectors. The brown
cable is connected to the positive terminal of
the rechargeable battery (marked in red on the
battery) and the black cable to the minus termi-
nal (marked in black on the battery).
Use the flat-nosed pliers to pull out the plug
connector. When so doing, pull on the plug
connectors and not on the cable.
Reinsert the new battery in the same way you
have removed the old.
Use the screws to re-fasten the fastening brack-
ets and the front of the main station.

Cleaning and storage

Slide the AUTO / OFF switch
position if you will not be using the spotlight
and want to store it.
32 GB/MT
if after a certain
20
into the OFF
4
. Remove
3
into the OFF
4
Charge the rechargeable batteries
3 months to prevent their destruction due to
deep discharge (see section "Charging the
rechargeable batteries"). Lead gel rechargeable
batteries have a high self-discharge rate.
Check the motion detector
cell for dirt regularly. If dirt or is present,
13
remove it to guarantee flawless function of the
spotlight.
Especially during the winter, keep the device
free from snow and ice.
Clean the spotlight with a lint-free, slightly moist
cloth and mild cleaning agent.

Troubleshooting

= Fault
= Cause
= Solution
= The spotlight does not switch on.
= The AUTO / OFF switch
= Slide the AUTO / OFF switch into the AUTO
position.
= The rotary control LUX
= Adjust the LUX control so it is brighter.
= The motion detector
6
oriented.
= Clean the motion detector or reorient it.
= The sensitivity of the motion detector is too low.
= Readjust the sensitivity of the motion detector (see
section "Adjusting the sensitivity of the sensor").
= The rechargeable battery
= Charge the rechargeable battery (see section
"Charging the rechargeable battery").
= The spotlight also switches on when it
is light out.
= The LUX control is adjusted too bright.
= Adjust the LUX control so it is darker.
= The spotlight flickers.
= The rechargeable battery is almost discharged.
= Charge the rechargeable battery (see section
"Charging the rechargeable battery").
every
20
and the solar
6
is in the OFF position.
4
is adjusted too dark.
8
is dirty or is incorrectly
is discharged.
20