Erreka DOLFIN Kurzführer Installation Und Programmierung Seite 9

DOLFIN
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings
IMPORTANT and other explanations which must be taken into account. The installation manual can be downloaded by
NOTE going to the "Downloads" section at the Erreka website:
http://www.erreka.com/Automatismos/descargaDocumentos.aspx
Elements of the complete installation
Electrical cabling
A: Main power supply
B: Flashing light
C: Photocells (Tx / Rx)
D: Pushbutton/wall key
E: Antenna
1 Make the M mark with a pencil.
4 Attach the operator to the base.
Mounting the track and the belt
2 Position the first section of the
profile and the three pins,
respecting their orientation.
>10cm
P154A2
5 Position the belt in the attachment
point (1), the cover (2) and the
tensioner nut (3).
2
3
P154G
Unlocking
Unlocking for manual operation:
Turn the key clockwise 270º.
Motorised operation locking:
Turn the key anti-clockwise 270º as far as
it goes (you should hear a CLICK), and
move the gate manually until it interlocks
in the drive mechanism.
3 Position the following profile
>10cm
1/2 1/2
P154E
6 Tighten the belt (with the
1
P154L
Unlocking
Locking
C l i C l i C l i
c k c k c k
! ! !
270
sections, ensuring they are securely
fitted.
>10cm
operator unblocked and the gate
in an intermediate position).
English
270
D154A
P154F
9
P154M