Maintenance; Symbols In This Manual - Ryobi R18BS Übersetzung Der Originalanleitung

12. Sanding belt (60 grit)
13. Sanding belt (100 grit)
14. Sanding belt (120 grit)

MAINTENANCE

WARNING
The product should never be connected to a power
supply when you are assembling parts, cleaning,
performing maintenance, or when the product is not in
use. Disconnecting the product will prevent accidental
starting that could cause serious injury.
WARNING
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING
Always remove the sanding belt from the product before
cleaning. Failure to do so could cause serious personal
injury.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
Do not at any time let brake uids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Electric tools used on berglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the berglass
chips and grindings are highly abrasive to bearings,
brushes and commutators. The manufacturer does not
recommend the use of the product for extended periods of
time on these types of materials.
After each use, remove the belt and dust collector if tted.
Clean the dust collector as shown in the illustrations in this
manual. Clean the tool thoroughly with a brush, dry cloth
and vacuum cleaner.
WARNING
Do not use compressed air to blow dust from the product
to prevent serious eye injury.
For greater safety and reliability, all repairs should be
performed by an authorised Ryobi service centre.
All of the bearings in this tool are lubricated with a suf cient
amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SYMBOL
Safety Alert
V Volts
No load speed
min ¹ Revolutions or reciprocations per minute
Direct current
CE Conformity
EurAsian Conformity Mark.
Ukrainian mark of conformity
Please read the instructions carefully before
starting the machine.
Wear ear protection
Wear eye protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.

SYMBOLS IN THIS MANUAL

Note
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
English | 3