6
2
Description and appropriate use
AED transducer electronics must only be used for measurement tasks with
strain gage full bridge transducers and directly associated control and regula-
tory tasks. Use for any purpose other than the above shall be deemed to be in-
appropriate.
In the interests of safety, the transducer electronics should only be operated as
described in the Operating Manual. It is also essential to observe the appropri-
ate legal and safety regulations for the application concerned during use. The
same applies to the use of accessories.
AED9x01 digital transducer electronics are part of the AED component family
that digitally conditions signals from mechanical measurement sensors and
networks them with bus capability. These include the digital amplifier board,
basic devices with an RS-232, RS-485, PROFIBUS DP, the CANopen or Devi-
ceNet interface and intelligent sensors with integrated signal conditioning. The
purpose of these components is to directly digitize and condition the measure-
ment signals at the transducer location.
The AD103C amplifier board can be installed in AED9x01x
provides mechanical protection, shields the amplifier board (EMC protection)
and allows you to select the serial interfaces, as well as implementing electrical
isolation appropriate to type.
1)
AED9401A and AED9501A to be equipped with AD103C only
HBM
AED System Digital Transducer Electronics
1)
basic devices. It
A1780−4.3 en/de/fr/es/it