Installation - Ingersoll-Rand 1 Serie Betriebs- Und Wartungshandbuch

Ingersoll-Rand No. 10
Ingersoll-Rand No. 28 Gearing
Ingersoll-Rand No. 67 Clutch
Always use an air line lubricator with this tool.
We recommend the following Filter-Regulator-Lubricator
(FRL) Unit:
Air Supply and Connections: Always use clean, dry air. Dust, cor-
rosive fumes and/or excessive moisture can damage the motor of an
air tool. An air line filter can greatly increase the life of an air tool.
The filter removes dust and moisture. Be sure all hoses and fittings
are the correct size and are tightly secured. See Dwg. TPD905-2 for
a typical piping arrangement.
LUBRICATION
Inside USA use FRL Unit # C08-02-FKG0-28
Outside USA use FRL Unit # C08-02-FKG0
After each 40,000 cycles or each month, whichever
occurs first, lubricate the gear train with Ingersoll-Rand
No. 28 Grease.
After each 40,000 cycles or each month, whichever
occurs first, inject 2 to 4 cc of Ingersoll-Rand No. 67
Grease into the Grease Fitting on the Angle Attachment.

INSTALLATION

Main Line(s) Inner Ø
to be 3X Size of
Air Tool's Inlet Ø
To Air
System
To Air
Tool
Emergency
Shut-Off
Valve
Lubricator Regulator
Drain Regularly
3
Branch Line(s) Inner Ø
to be 2X Size of
Air Tool's Inlet Ø
R
L
F
Filter
FRL
Compressor
(Dwg. TPD905-2)