Installation; Electrical Installation - Dräger VarioGard series Gebrauchsanweisung

Error message or
warning
Transmitter 1 Electronic fault
Error !
Transmitter 1 Transmitter operating
time about to expire.
Mainten.
recommend !
Transmitter 1 Transmitter operating
time has expired and the
Mainten. necessary !
sensor is no longer
working properly
Dräger VarioGard Central unit not
connected to mains
Emerg. power
supply !
Voltage loss
Dräger VarioGard
Cause Remedy
Replace transmitter or
have it repaired by
Dräger Service.
Install new transmitter or
have Dräger Service
check the transmitter.
Install new transmitter or
have Dräger Service
check the transmitter.
Check installation and
correct.
Correct voltage loss.
7

Installation

Details on the mechanical installation and the wiring diagram are
available in the following documents:
VarioGard central unit
Installation according to the installation instructions 90 23 573.
VarioGard 3x00 transmitter
Installation according to the installation instructions 90 33 163.
VarioGard battery module
Installation according to the installation instructions 90 23 579.
VarioGard Relay Module
Installation according to the installation instructions 90 23 577.
VarioGard Converter Module
Installation according to the installation instructions 90 23 578.
VarioGard Repeater Module
Installation according to the installation instructions 90 23 729.
7.1

Electrical installation

WARNING
!
The VarioGard system wiring may only be routed and connected
by an electrician in accordance with the relevant regulations.
Do not connect the instruments to the power supply before
the wiring has been completed and tested.
NOTICE
i i
Shielded cables are not required.
Installation
35