Loewe Xelos A 42 Serviceanleitung Seite 16

W1009 / P2002
1 – +5V
2 – +5V
– im Panelmenü - Cursor hoch = 0V , Cursor runter = 1V
at the panel menu - Curor up = 0V , Cursor down = 1V
3 – +5V –
im Panelmenü - Cursor rechts = 0V , Cursor links = 1V
at the panel menu - Cursor right = 0V , Cursor left = 1V
4 – Panel ein/on = 0V, Panels aus/off = 5V
5 – Masse/GND
W1008 / P2006 (P2006 ist über Kreuz angeschlossen/connector P2006 cross-linked)
1 – Recovery Sequenz = 5V
2 – CSENS nb. = 5V
3 – n.b. = 0V
4 – Panel Reset = 0V
5 – FLASH_W = 0V
6 – CCKM = 1,9V
7 – Masse/GND
8 – RX UART = 5V
9 – TX UART = 5V
10 – Masse/GND
11 – n.b.
12 – SMPOW = 4,4V
13 – n.b.
14 – n.b.
P7706 / CN7601
1 – Temp. = 2,2V
2 – Masse/GND
3 – REG1 -
Lampen an = 3V, Lampen aus = 0V
Lamps on = 3V , Lamps off = 0V
4 – IS1-1
5 – IS1-2
P 7705 / CN7502
1 – Masse/GND
2 – STB = 2,8V
3 – OFL = 2,7V
4 – n.b.
5 – INV OSC
6 – INV ERR – normal 3V , bei Fehler/Fault 0V
7 – REG – siehe/see P7706 REG1
8 – IS1 – siehe/see P7706 IS1-1
9 – IS2 – siehe/see P7706 IS2-1
10 – n.b.
11 – n.b.
12 – n.b.
16