E/A-Leiste - Siemens ES PCS7 Funktionshandbuch

Baugruppentreiber/Maintenance Station

5.4 E/A-Leiste

5.4 E/A-Leiste
Anschlüsse
Der Auslieferungszustand der Bausteindarstellung im CFC ist in der Spalte "Default"
gekennzeichnet:
Parametername fett = Anschluss sichtbar
Parametername normal = Anschluss nicht sichtbar
Tabelle 5-1 Parameter DES_DIAG
Parameter Type
ACC_ID BOOL
DADDR INT
DELAY INT
EN_DIAG BOOL
LADDR INT
MODE WORD
OMODE DWORD
PA_DIAG DWORD
QEN_RDWR BOOL
QERR BOOL
QMODF BOOL
QPERAF BOOL
QRACKF BOOL
RACK_NO BYTE
RACK1ERR BOOL
RACK2ERR BOOL
RACKF BOOL
SUBN_TYP BOOL
SUBN1_ID BYTE
SUBN1ERR BOOL
SUBN2_ID BYTE
SUBN2ERR BOOL
48
Art Default Kommentar
INOUT TRUE =1:
IN 0 Diagnostic address of module
IN 15 Alarm delay (sec)
IN FALSE =1:
IN 0 Logical address of module
IN 0 Parameter OMODE of SMC_DIAG
OUT 0 Status MODE
OUT 0 Diagnostic information for maintenance
OUT TRUE =1:
OUT FALSE =1:
OUT FALSE =1:
OUT FALSE Access error
OUT FALSE =1:
IN 16#00 Rack number
OUT FALSE =1:
OUT FALSE =1:
IN FALSE =1
IN FALSE =1:
IN 16#FF ID of primary subnet
IN FALSE =1:
IN 16#FF ID of redundant subnet
IN FALSE =1:
Accept new mode settings
Enable read diagnostic data
Enable read / write record
Error
Module failure
Rack failure
DP slave system failure (primary)
DP slave system failure (redundant)
Rack failure
External DP interface
Slave 1 failure
Slave 2 failure
Funktionshandbuch, 11/2016, A5E39409968A AB
S7_m_c :=TRUE
Baustein APL_MM4