When The Flash Is Connected Using The Underwater Ttl Cable - Olympus UFL-2 Bedienungsanleitung

When the flash is connected using the underwater TTL cable

Let's try shooting pictures using the TTL AUTO mode. In TTL AUTO mode
the flash intensity is controlled automatically according to the camera's
settings.
AUTO CHECK lamp
1 Set the camera's shooting mode to one of the underwater modes.
2 Press the MODE button of the electronic flash repeatedly to set the flash
control mode to [TTL AUTO].
3 Press the shutter button halfway.
• Shooting information will be communicated between the camera
and the electronic flash and the light control range will be displayed
on the control panel.
• If the subject is not within the light control range, adjust the distance
to the subject.
• The light control range will vary according to the camera's setup
(ISO sensitivity, aperture value and focal length of the lens).
4 Press the shutter button fully.
• When flash activation has been performed correctly, the AUTO
CHECK lamp blinks for about 5 seconds after the shutter is
released.
Flash control mode
Firing angle
Displayed according to the
focal length of the lens.
Light control range
MODE button
EN
EN 25