Channel Selection; E) Sensor Search Mode; Trend Display - Eurochron EFUS 750 Bedienungsanleitung

d) Channel selection
• If you use multiple outdoor sensors (max. 8), press the button CHANNEL/+, to switch between the channels.
• If you select the circular arrow, the data of all outdoor sensors are displayed cyclically at intervals of 5 seconds.

e) Sensor search mode

• If the connection to one of the sensors has been interrupted, lines appear on the display instead of the measured
value.
• Keep the button CHANNEL/+ depressed for 3 seconds, to call up the search mode.
• Press the button HISTORY/- or CHANNEL/+, to select the required sensor:
- CH (1-8) for the outdoor sensors
- WIND (wind sensor)
- RAIN (rain sensor)
- ALL (all sensors; select this option if you add new sensors, if you remove sensors or if the signal of several
sensors has been lost)
- NOT (select this option if you do not want to search for any sensor)
• To confirm, press the button SET. The reception symbol appears next to the sensor name
been received, the reception symbol disappears and the current measured value is displayed.
f) Trend display
• In normal display mode, press the button HISTORY/-, to display the following graphs:
- Wind speed (WIND)
- Precipitation (RAIN)
- Barometer (BAROREL)
- Indoor temperature (TEMP-IN)
- Indoor humidity (HUMI-IN)
- Outdoor temperature (TEMPOUT)
- Outdoor humidity (HUMIOUT)
The hours (72 or 24) are indicated on the horizontal axis (X-axis).
The deviation from the current measured value is indicated on the vertical axis (Y-axis). The scale at the
right border of the display is adapted automatically.
The most current value is always displayed as 0 outside on the right. If, for example, in temperature mode
a bar indicates the value 0.4, then the temperature at this time was 0.4 degrees higher than the current
temperature.
With outdoor temperature and outdoor humidity, the graph of the currently selected channel is displayed.
. After the signal has
59