Appendix 2: Data Tag Information - ESAB Cutmaster 100 Handbuch

ESAB CUTMASTER 100

APPENDIX 2: DATA TAG INFORMATION

M odel :
Dat e of M f r :
Type of Power
1/ 3
Supply (Note 1)
Output Current Type
Plasma Cutting
Symbol
Rated No-
Load Voltage
Input Power
Symbol
Input Power
Specifications
(Phase, AC or DC
Hertz Rating)
Degree of Protection
NOTES:
1. Symbol shown indicates single- or three-phase AC input,
static frequency converter-transformer-rectifier, DC output.
2. Indicates input voltages for this power supply. Most power
supplies carry a label at the input power cord showing input
voltage requirements for the power supply as built.
3. Top row: Duty cycle values.
IEC duty cycle value is calculated as specified by
the International ElectroTechnical Commission.
TDC duty cycle value is determined under the power supply
manufacturer's test procedures.
Second row: Rated cutting current values.
Third row: Conventional load voltage values.
4. Sections of the Data Tag may be applied to separate areas
of the power supply.
A-2
f
1
f
2
Duty Cycle Factor
X
I
U
0 =
U
2
Conventional
Load Voltage
I
U
1
1Ø 1
Rated Supply
Voltage (Note 2)
S/N
Rated Maximum
Supply Current
I
1max 1eff
3Ø 1Ø 1 3Ø
Standard Symbols
Ø
APPENDIX
Manufacturer's Name and/or
Logo, Location, Model and
Revision Level, Serial Number
and Production Code
Regulatory Standard Covering
This Type of Power Supply
Output Range (Amperage/
Voltage)
Duty Cycle Data (Note 3)
Maximum Effective
Supply Current
Manufacturer's Electrical
Schematic File Number
and Revision Level
AC
DC
Phase
Art # A-12765_AA
Manual 0-5397