How To Operate (Without Timer Operation) - Panasonic CS-W18BTP Bedienungsanleitung

4-2 How to operate
AIR SWING
LOCAL MANUAL
CZ-RD51P
AIR SWING TIMER
SELECT
AUTO
MANUAL
TEST RUN CLOCK CANCEL
Press B to select the desired operation mode.
2
The display changes in this order.
OPE-
RATION
FAN
AUTO operation
Indoor unit will automatically detect the temperature differences between the remote control set temperature and the inlet
air temperature, and automatically switches operation between HEAT, FAN and COOL mode to maintain a constant room
temperature.
(For Cooling models, the operation mode switches between COOL and FAN to maintain a constant room temperature.)
DRY operation
Indoor unit will automatically switch to cooling operation with a low fan speed.
(The outdoor unit will be cut-off if the room temperature is less than 21°C or the remote control set temperature is higher
than the room temperature.)
Press C to select the setting temperature (16°C – 31°C).
3
UP
Press to increase temperature by 1°C.
Press D to select the fan speed.
4
The display changes in this order.
FAN FAN
SPEED SPEED
MED HI
(without timer operation)
TIMER OPE-
FAN
TEMP
SPEED RATION
HEAT
MED
OFF / ON
FAN OPE- TEMP
UP
SPEED RATION
SET
DOWN
FILTER
CHECK A/C No.
RESET
For Heat Pump models
OPE- OPE- OPE-
RATION RATION RATION RATION
AUTO
COOL
DRY
FAN FAN
SPEED SPEED
AUTO
LO
NOTES
Once a button has been pressed to make a setting, the
setting will be retained even though the OFF/ON button is
pressed to stop and restart the operation.
(You will need to reset the timer if the power supply for the
unit stops for an hour or more due to power outage or
disconnected from the power supply. However, depending
on the ambient temperature, there may be cases where the
setting is cleared within an hour.)
Press A to start the operation.
1
Press once more to stop the operation.
OPE-
HEAT
DOWN
Press to decrease temperature by 1°C.
AUTO fan speed
Indoor unit will detect the temperature differences between the remote
control set temperature and the inlet air temperature, and switches the
fan speed accordingly.
The larger the difference between the two temperatures, the greater will
be the fan speed. (If the operation mode is set to FAN, the fan speed will
be fixed at MED regardless of the temperature difference.)
– 7 –
For Cooling models
OPE- OPE- OPE- OPE-
RATION RATION RATION RATION
AUTO
FAN
COOL
DRY