Preliminary Measures Prior To Starting Up; Mounting The Device; Starting-Up; Turning On/Off The Ventilator And Heating Levels - Silvercrest SHO 2000 A1 Bedienungs- Und Sicherheitshinweise

Safety / Preliminary measures prior to starting up / Starting up
Defective components may
Q
only be replaced with origi-
nal spare parts. Only if orig-
inal spare parts are used, it
is ensured that the security
requirements are met.
Protect the device against
Q
humidity and penetration of
liquids.
When disconnecting, pull
Q
the power cable from the
wall socket by the power
plug only, do not jerk out the
cable!
Do not use the device in the
Q
vicinity of open flames.
Do not place the device di-
Q
rectly under or above a wall
socket.
In the case of faults or during
Q
a thunderstorm, pull out the
connector plug from the wall
socket.
Never use the device in the
Q
direct vicinity of a bath tub,
shower or swimming pool.
Use the device only when the
Q
power cable is completely
run out. Never wind the pow-
er cable around the device.
Make sure that the power ca-
ble does not contact hot sur-
faces. Route the cable so that
nobody can stumble over it.
10 GB/NI/IE
P reliminary measures prior to

starting up

Mounting the Device


□
Remove all packaging material and all
transport bracing from the device.
For a safe and trouble-free running of the de-
vice, choose the installation location which meets
the following requirements:
- The floor should be firm, flat and horizon-
tal.
- Keep the following minimum clearances
from the device housing: 50 cm from its lat-
eral side, 50 cm above, 50 cm from its rear
side and 50 cm from its front side.
- Do not place the device in a hot and wet or
very humid environment or near combus-
tible material.
- The socket should be easily accessible so
that the mains connection cable can be
easily disconnected, if necessary.
- Temperature range: from 0 to +40 °C
- air humidity (no condensation): 5–75 %
Please note: When you use the device the first
time, a slight odour may occur.
Starting up

Turning ON/OFF the ventila-

tor and heating levels
□
Make sure that the heating level switch
2 is set on 0. Then connect the heater to
a grounded socket protected by a residu-
al-current device with overload protection.
Ensure a free rotation of the fan.
□
Then turn the appliance ON by clockwise
turning the temperature regulator 5 until
you hear a click and set the heating level
switch 2 to the desired position. The con-
trol light 1 illuminates. Thus defined: