RP74339 KeramikHL LB4so2 Seite 7 Montag, 7. Mai 2012 2:19 14
Note: As the appliance and heating coils
are supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack
the
packaging.
2. Remove the transport packaging.
3. Check that the appliance shows no signs
of damage.
Warning!
– While
operating, there must be no
flammable objects (e.g. curtains,
paper) in the immediate vicinity
of the appliance.
– When setting up the appliance,
maintain a minimum distance of
0.5 m from other appliances and
the wall.
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– Remove the mains plug before
each clean.
– Allow the appliance to cool
down.
– Never immerse the appliance in
water.
– Never allow water or cleaning
agent to run into the appliance.
SKHD 1800 A1
5. Unpacking and setting up
appliance
from
the
the
appliance
is
6. Cleaning
4. Select a location that complies with the
safety
information
information" on page 4).
5. Select a location where the flow of hot
air is not directly aimed at people,
animals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note: The appliance consumes up to
9 amperes of current (1800 watts). If
you
have
plugged
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
6.1 Cleaning the appliance
1. Carefully remove major dust deposits in
the air outlet grille 7 with a vacuum
cleaner.
2. Remove any remaining dirt with a soft
brush.
Take care not to let any dust fall inside
the appliance.
3. Clean the outside of the appliance with a
damp cloth. You could also use a little
washing-up liquid.
(see
"4. Safety
other
power
7