Error Displays; Troubleshooting - Omron BF206-BT Bedienungsanleitung

HBF-206IT-E_A_M.book Page 17 Wednesday, March 10, 2010 12:04 PM

11. Error Displays

Error Display

12. Troubleshooting

Problem
The displayed value of body
composition is abnormally high or low.
"- - - -" is displayed for some items of
the measurement results.
The power turns off after the body
weight is confirmed and before your
body fat percentage, visceral fat level,
skeletal muscle percentage, BMI and
resting metabolism is measured.
Nothing is displayed when the power
is turned on.
Data cannot be sent.
("Err" indicator lights.)
Cause
Your soles are not in firm contact with the
electrodes.
The posture for measurement is wrong
or the soles are not in firm contact with
the electrodes.
The soles are too dry.
Device error.
You stepped on or moved the unit before
the display indicated "0.0 kg".
You moved your body while measuring
body weight.
Your weight is more than 150 kg (330.0 lb).
Refer to "Information on Body Composition".
Values of body composition are out
of measurable range.
You did not select the correct
personal profile number or the
GUEST mode. (The personal
profile number or "GUEST" is not
displayed on the display unit.)
Batteries are not inserted.
The polarities of batteries are not
aligned correctly.
The batteries are worn out.
The destination device for the data
is too far away.
Pairing (registering) has not been
completed.
The application on the connected
device is not ready.
Correction
Press your soles firmly to the electrodes, then
measure. (Refer to Section 5.)
Measure without moving the soles. (Refer to
Section 5.)
Moisten the soles with a wet towel, then repeat
measurement.
Insert the batteries again and repeat
measurement.
If this error still occurs, consult your OMRON
service representative.
Step on the unit after the display indicates
"0.0 kg".
Do not move while measuring body weight.
Body weight of more than 150 kg (330.0 lb) is
out of the measuring range of this unit. You
cannot use this unit.
Cause
• Please ensure that birth date,
gender and height settings stored
as personal data are correct. (Refer
to Setting Items in Section 13.)
• The unit cannot measure body
composition outside its
measurement range, even if the
settings are correct.
Select the correct personal profile
number or the GUEST mode.
(Refer to Section 5.)
Insert the batteries.
Insert the batteries in correct
alignment.
Replace all four batteries with new
ones. (Refer to Section 2.)
After checking that there are no
sources of interference nearby,
move the device to a distance
within 5 m of the unit.
Perform pairing (registration).
(Refer to Section 8.)
Check the application then try
sending the data again.
If the "Err" indicator still lights after
checking the application, contact
the service (support) center of the
application provider.
Correction
EN
17