Toshiba RBC-TWP30E2 Installationsanleitung Seite 14

INDOOR UNIT OPERATION WHEN CONNECTED TO MULTIPLE UNITS
Procedure
Specify the CODE No. [13] with the temperature [
4
(CODE No. [13] : Indoor address)
- 1
Change the indoor address from [3] to [2] with the timer time
4
[ /
- 2
SET
Push button.
4
If the display changes from flashing to being lit, the setting is completed.
- 3
Specify the CODE No. [14] with the temperature [
5
(CODE No. [14] : Group address)
- 1
Change the SET DATA from [0001] to [0002] with the timer time
[ /
5
- 2
(SET DATA : [Main unit: 0001] [Sub unit: 0002])
SET
Push button.
5
- 3
If the display changes from flashing to being lit, the setting is completed.
If there are some other indoor units of which setting is to be changed,
repeat the procedure
After the above setting is completed, push
unit No. which had been given prior to the setting change, and then specify
the CODE No. [12], [13] and [14] with the temperature
[ /
6
Check of address change Prior to the change [3-3-1]
→ After the change [2-2-2]
The setting change which has been made can be cleared by pushing
button.
(In this case, perform the setting again from Procedure
After checking the changes made, push
be confirmed). If
air conditioner will be in ordinary stop state.
(The commands from the remote controller cannot be received for
7 approximately 1 minute after pushing
• If the commands from the remote controller is not received even after 1
minute has elapsed, the address setting may be incorrect. In this case,
perform the setting again from Procedure
setting has been made again.
] button.
] button.
2 5
– to change the setting.
] button successively to confirm the changes made.
TEST
button is pushed, the display will disappear and
Description
/
/
UNIT LOUVER
button to select indoor
2
.)
TEST
button (the changes will
TEST
button.)
1
as the automatic address
– 14 –
] button. Indoor unit numbers which had
been given prior to the setting
change will be displayed.
] button. Indoor unit numbers which had
been given prior to the setting
change will be displayed.
Indoor unit numbers which had
been given prior to the setting
change will be displayed.
CL
SETTING