Troubleshooting - NAD C320 Bedienungsanleitung

Problem
NO SOUND
NO SOUND ONE CHANNEL
WEAK BASS / DIFFUSE STEREO IMAGE
REMOTE CONTROL HANDSET
NOT WORKING
POWER/PROTECTION LED TURNS RED
DURING OPERATION

TROUBLESHOOTING

Cause
• Power AC lead unplugged or power not
switched on
• Tape 1 Monitor selected
• Mute on
• Rear Pre-out/Main-in amp links not
fitted
• Headphones inserted
• Balance control not centered
• Speaker not properly connected or
damaged
• Input lead disconnected or damaged
• Speakers wired out of phase
• Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows
obstructed
• IR receiver in direct sun or very bright
ambient light
• Amplifier has overheated
• Overall impedance of loudspeakers
too low
Solution
• Check if AC lead is plugged in and
power switched on
• De-select Tape 1 Monitor mode
• Switch off Mute
• Fit links
• Disconnect headphones
• Center Balance control
• Check connections and speakers
• Check leads and connections
• Check connections to all speakers in
the system
• Check or replace batteries
• Remove obstruction
• Place unit away from direct sun, reduce
amount of ambient light
• Turn amplifier off, make sure ventilation
slots on top and bottom of amplifier are
not blocked. After amplifier has cooled
down, turn back on
• Ensure the overall loudspeaker
impedance is not below 4 ohms
GB
7