OHAUS SHRK04DG Bedienungsanleitung Seite 11

DIGITAl ROCKING/WAVING SHAKER OPERATING INSTRUCTIONS CONT'D
5. Setting timed mode: Programmed time.
a. Press the up/down arrows below the time display until you reach the desired
time.
b. Start this function by pressing the on/off button below the time display. The unit
will run for the selected time, the up/down arrows will become inactive while the
timer is running. The unit will stop rocking/waving when the time display reaches
zero (0:00). Four (4) audible beeps will indicate the count down function is
complete. The time display will default back to the set time. To repeat for the
same time, simply press the on/off button again.
c. To interrupt an automatic timing cycle before it is completed, press the on/off
button below the time display. The time display will flash off and on to indicate
the time function is on "hold". IMPORTANT: This will NOT interrupt the rocking/
waving function. Press the on/off button below the speed/tilt angle display to
interrupt the rocking/waving function. Restart the timer by pressing the on/off
button below the time display. Unit will continue counting down to zero (0:00).
When the display reaches zero (0:00), you will hear the four (4) audible beeps
that indicate the count down function is complete and the rocking/waving
function will cease.
6. Turning unit off:
a. To turn the unit off, press the standby button. The speed/tilt angle and time
displays will be blank, the standby indicator light will illuminate. The Rocking/
Waving Shaker should be kept in standby mode when not in use. To completely
cut off power to the unit, disconnect the power cord from the unit or unplug from
the wall outlet.
OPERATING TIPS
As a safety feature, a built-in program will shut power off to the motor if the tray is
prevented from rocking/waving, or the unit is overloaded beyond its recommended
weight capacity.
Built-in memory maintains the last used speed/tilt angle and time settings during a
power interruption.
EN
10