Acson international A5WMY10KR Handbuch Seite 9

01_EN_3P257186-2A.fm Page 8 Saturday, October 31, 2009 2:19 PM
Preparation before Operation
■ Turn the breaker on
• Turning on the breaker opens the flap, then closes it again. (This is a normal procedure.)
NOTE
■ Tips for saving energy
• Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate
level helps save energy.
• Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them once in about
every 2 weeks.
■ Please note
• The air conditioner always consumes 15-35W of electricity even while it is not operating.
The outdoor unit consumes 1-10W to have its electric components work even while it is not
operating.
During standby electricity saving mode : about 1W
The outdoor unit consumes about 35W of power at the time of compressor preheating.
• If you are not going to use the air conditioner for a long period, for example in spring or
autumn, turn the breaker off.
• Use the air conditioner in the following conditions.
Mode Operating conditions
COOL Outdoor temperature: 10-46°C
Indoor temperature: 18-32°C
Indoor humidity: 80% max.
HEAT Outdoor temperature: –15-24°C
Indoor temperature: 10-30°C
DRY Outdoor temperature: 10-46°C
Indoor temperature: 18-32°C
Indoor humidity: 80% max.
• Operation outside this humidity or temperature range may cause a safety device to disable
the system.
8
Recommended temperature setting
For cooling: 26-28°C
For heating: 20-24°C
If operation is continued out of this range
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.