Preparation Before Operation - Acson international A5WMY10KR Handbuch

01_EN_3P257186-2A.fm Page 7 Saturday, October 31, 2009 2:19 PM

Preparation before Operation

■ To set the batteries
1. Push down the hook and open
the back cover.
2. Set two dry batteries AAA.LR03
(alkaline).
3. Return the back cover to the
previous position.
■ To operate the remote
controller
• To use the remote controller, aim the transmitter at the indoor unit.
If there is anything to block signals between the unit and the
remote controller, such as a curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is approx. 7m.
■ To fix the remote controller holder
on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the screws procured locally.
3. Hang the remote controller on the remote
controller holder.
NOTE
■ Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approx. 1 year. If the remote controller display begins to fade and
the degradation of reception performance occurs within a year, however, replace both
batteries with new, size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
■ Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance
to somewhere else, or consult the shop.
1
3
2
Position + and
– correctly!
Receiver
Remote controller
Screws
Remote
controller holder
7