Description Of Unit; Fsa 720 Front View; Fsa 720 Terminal Strip - Bosch FSA 720 Betriebsanleitung

3.5

Description of unit

The FSA 720 consists of the measuring unit, a power
pack with mains connecting cable for the measuring
device's supply voltage and a USB connecting cable for
connection to a PC. Also included in the delivery are
various sensors for recording values.
The FSA 70 may be damaged by, e.g. falling
if it is not properly mounted. For this reason
injuries or damage cannot be ruled out. The
FSA 70 must always be properly mounted.
Danger of tripping
When the FSA 720 is transported with the
sensor cables there is an increased risk of trip-
ping. Contusions, fractures, head injuries may
also be caused by tripping up.

Always remove sensor cables before any
transport!
3.5.1 FSA 70 front view
15
- KV +
15+ -1
Abb. 1:

FSA 720 front view

Bosch Diagnostics
15
15 15
p
A 1 2
1 CH 2
4597755-Ko
Product description | FSA 70 | 19
3.5. FSA 70 terminal strip
KV-
COM
15+ - 1
1 2 3 4 5 6 7 8 9 10 11 12 13 14
Abb. 2: FSA 720 terminal strip (from below)
1 Temperature sensor
2 Connecting cable B+/B‒
3 Connecting cable terminal 1 / terminal 15 / EST / TN/TD
4 Trigger clamp or adapter cable 1 684 465 513 for clip-on sensor
5 RS 232 serial interface (without function)
6 KV– sensor
7 USB connection for PC data connection
8 KV+ sensor
9. Measuring unit power supply (power pack)
10 Multi measuring cable CH1 or current clamp 30 A
11 Multi measuring cable CH2 or current clamp 30 A or
current clamp 1000 A
12 Stroboscope
13 Air pressure measurement
14 Liquid pressure sensor
When measuring speed using the clip-on sensor, the adapter
*)
cable 1 684 465 513 must always be connected between the
FSA 740's plug socket and the connecting cables for the clip-on
sensor.
Voltages of no more than 00 V may be
measured at the multi measuring cables
CH1 / CH.

Never apply higher voltages.
en
D X
KV+ CH1 CH2
USB 15V DC
45977541-Ko
|
1 689 979 894 2007-01-30
*)