Installation; Control Buttons - Miro TD570 Bedienungsanleitung

I
NSTALLATION
Follow these steps to install the monitor
1. Before you connect the cables, make sure the monitor and system
unit power switches are OFF.
2. Plug one end of the 15-pin signal cable to the rear of your system
and the other end to monitor's signal input. The adapter may be
required for certain Apple Macintosh computers. Tighten the two
screws on the cable connector.
3. Attach the power cord to the "POWER IN" jack of the LCD monitor.
Plug the end of power cord into an AC wall outlet.
5. Turn on your computer and your LCD monitor.
VESA FPMPMI (Wall Mount) compatible
u
v POWER IN jack
w Signalcable
4
u
v
w
C B
ONTROL UTTONS
Front Controls
u
v
w
x
y
z
uvwx y z
B D :
UTTON ESCRIPTION
u : Menu button
To push menu button turns on the menu, and it activates
the items you highlight.
: Select button
vw
To choose which function you need in OSD Menu and to
increase and to decrease the function, you may click
x : Auto button
Press "2" button 2 seconds the auto adjust display mode
will tune to the utmost performance according to VGA
setting. In the event of the display image needs further
adjustment. To ensure best Auto-Adjustment perfomance :
Press "A" button for 2 seconds
The monitor display will be then best adjusted.
y : Power indicator
This light glows green during normal operation and glows
orange during power off. Glows orange and flash during
power saving mode.
z : Power button
Use this button to turn the monitor on and off
Menu button
Select button
Select button
Auto button
Power Indicator
Power button
or
5