Siemens 7MF8 23-Serie Kompaktbetriebsanleitung Seite 17

– Turn the shield over the insulation. See Fig.
– Firmly press in the plastic seal. The O-ring will in turn press the shield against the enclosure.
5. Screw on the cable gland cover with a 23 mm open end wrench until strain relief is ensured.
6. Strip the wires.
7. Connect the wires to the terminals
Ensure correct polarity! If necessary, ground the device using the
8. "-" connection by connecting the "-" connection to the ground terminal
①
Connecting terminals
②
Ground terminal with plastic cable gland
③
Guide channel
④
Ground terminal for cable gland with metal cable
gland
Figure 2 Electrical connection, power supply
SITRANS P300 (7MF8.23.. 7MF8.24.. 7MF8.25..)
A5E03434657-01, 08/2011
①
"+" and "-".
②
.
⑤
Auxiliary power U
⑥
Load
⑦
Cable gland
H
17