Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HKG30:
Direct country of destination
Gas category
International protection rating
Supply gas pressure
Voltage
Power consumption
Gas consumption
Heat capacity
Airflow
Classification gas appliance
THE SMELL OF GAS
An odour is added to gas to allow you to tell if there is a gas leak. Gas is heavier than
air; so try to smell the gas right above the floor.
Immediately shut off the gas supply.
Don't do anything to cause sparks or fire to prevent inflammation of the gas. Do not
switch electricity on or off, do not light matches, lighter or the like and do not use your
telephone.
Get everyone out of the vicinity of the gas source and give the gas ample time to air
out. Stay nearby during that process. If you still smell gas or have doubts about the
situation, contact the fire department.
Have a gas leak repaired by qualified people.
Operation:
1. Check the heater for damage or defects. Do not use a damaged heater, but contact
your supplier.
2. Make sure to use undamaged, full gas bottles with propane or butane, suitable for
use.
3. Select a place for the heater that meets all the safety instructions and place it on a
level, stable, horizontal surface with non-flammable material. Do not plug it in and
the set the power switch to O (off).
4. Firmly attach the gas hose with suitable tools to the pressure regulator (left screw
threads!)
5. Remove the protective cap and attach the gas supply hose to the device (left screw
threads!). Firmly screw on the nut with suitable tools for unproblematic gas supply.
Immediately take measures if you smell gas!
Belgium
I3B/P (1500) – propane or butane
IPX0
mBar
1500
V/Hz
220-240 / 50
W
65
g/hour
2400
kW
33
m³/hour
1000
A3
17
Werbung
