Parkside PDKS 120 A2 Originalbetriebsanleitung Seite 52

Anleitung_LB5_4309025:_
GB/
MT
Never cut workpieces which are too small to
■
hold securely in your hand.
Never load the machine so much that it cuts
■
out.
Always press the workpiece firmly against
■
the saw table.
Never remove loose splinters, chips or
■
jammed pieces of wood when the saw blade
is running.
Switch the machine off to rectify faults at the
■
blocked plug-in tool. - Pull the power plug-
Remove the blockage. Important! Risk of
injury from saw blade! Wear gloves. Carry
out a trial run without a workpiece. Ensure
that no unusual noise or vibration occurs.
Should this be the case, switch the unit off
and contact the manufacturer.
Carry out retooling work, adjustments,
■
measurements and cleaning jobs only when
the motor is switched off. - Pull the power
plug. -
Before switching on, make sure that all keys
■
and wrenches have been removed from the
tool.
Switch off the motor and pull the power plug
■
before you leave the workplace.
Electrical installation work, repairs and
■
maintenance may only be carried out by
persons who have been specially trained.
Refit all guards and safety devices
■
immediately after you have completed any
repairs or maintenance work.
Be sure to observe the safety information
■
and operating and maintenance instructions
issued by the manufacturer, as well as the
dimensions listed in the Technical Data.
It is imperative to observe the accident
■
prevention regulations in force in your area
as well as all other generally recognized
rules of safety.
Note the information published by your
■
professional associations (VBG 7j).
The saw is intended to be used indoors
■
only.
Workpieces that are smaller than the saw
■
blade guard can cause injuries to the hands
or fingers. Use suitable aids!
Avoid cramped hand positions when guiding
■
in the workpiece and avoid positions in
which slipping could lead to your hand
52
25.05.2011 14:03 Uhr Seite 52
making direct contact with the saw blade.
Always fit the saw blade with the teeth
■
facing in the direction of the sawing table.
Always set the correct blade tension to
■
prevent the saw blades from jerking.
Be especially careful when cutting material
■
with irregular cut profiles.
Exercise particular caution when cutting
■
round objects such as rods and pipes.
These can roll down into the saw blade and
cause the teeth to catch. Use a wedge to
brace such workpieces.
The teeth can become caught in the kerf
■
when the workpiece is pulled back,
especially if sawings have filled in (blocked)
the kerf. In this case, you should switch the
saw off, pull the power plug, clear the kerf
with a wedge, and remove the workpiece.
Never leave the work area without having
■
already switched the saw off. Wait until the
saw stops moving completely.
Do not position, join, or construct any parts
■
on the work table while the saw is running.
Only switch the saw on after you have
■
removed any remaining material and tools
from the work table. Leave only the
workpiece to be machined and any aids
(e.g. wedges) on the work table.
Always wear safety goggles!
■
Keep your fingers at a safe distance from
■
the saw blade.
Carefully guide the workpiece and keep it
■
steady at all times.
Never leave the work area without having
■
already switched the saw off.
Do not let your familiarity with the saw allow
■
you to be careless. Carelessness can lead
to severe injuries within a fraction of a
second.
Do not lose this safety information.