Troubleshooting - Graco AquaMax 2330E Bedienungsanleitung

7 Troubleshooting

Fault
Pressure drop
Pressure fluctuations
The motor does not start when the
cleaner is switched on
When the cleaner is switched on
the motor buzzes without starting
The motor switches off
No detergents drawn in
Options / model variants
1)
Original instructions
Cause
• Air in the system
• High pressure nozzle blocked
worn
• Detergent tank empty
• Pump draws in air (only pos-
sible in suction mode)
• Lack of water
• Water inlet hose is too long or
its cross-section too small
• Lack of water caused by
blocked water filter
• Lack of water because max.
permissible suction height has
not been heeded
• The plug is not inserted prop-
erly, i.e. there is no current
• The mains fuse is switched off •
• The mains voltage is too low or
there is a phase failure.
• The pump is blocked or frozen •
• Incorrect cross-section or
length of the extension lead
• The overload protection has
been activated due to over-
heating or overloading of the
motor
• High-pressure nozzle is dirty
• Injector is dirty or suction hose
is blocked
• Detergent tank empty
• The cap on the FlexoPowerJet
nozzle is not set to low pres-
sure
Remedy
• Vent the system by operating
the spray gun several times at
short intervals. If necessary,
operate the cleaner for a short
time without the high-pressure
hose connected.
• Clean/replace the high pres-
sure nozzle
• Top up detergent tank or set
detergent metering to "0"
• Check that the suction set is
air-tight
• Open water tap
• Use specified water inlet hose
• Clean the water filter in the
water connection (never work
without water filter)
• See instructions
• Check the plug, lead and
switch and if necessary have
them replaced by a trained
electrician
Switch on the mains fuse
• Have the electrical connection
checked
Contact the GRACO customer
service
• Use lead with correct cross
section or length
• Check that the mains volt-
age and the cleaner voltage
are the same. Switch off the
cleaner and allow it to cool for
at least 3 minutes
• Change the high-pressure
nozzle
• Clean
• Top up detergent tank
• See chapter 4.
English
15