Husqvarna TC 250 2012 Bedienungsanleitung Seite 75

REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer on the wheel hub (A).
Fit the wheel between the front fork legs so that the brake disc
is fitted into the caliper.
A
Working on right side, push the previously-greased wheel axle
(2) all the way down, tapping it on left fork leg; during this
operation, the wheel should be turned. Tighten the screw (3) on
the fork L.H. side but DO NOT lock it.
Now, pump for a while, pushing the handlebar downwards until
you are sure that the fork legs are perfectly aligned.
Lock: the screws (1) on the R.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7
ft-lb), the screw (3) on the L.H. side (51,45 Nm/ 5,25 Kgm/
38 ft-lb), the screws (1) on the L.H. leg (10,4 Nm/ 1,05 Kgm/
7.7 ft-lb).
1
3
2
1
SPECIFICATIONS - OPERATION - MAINTENANCE
NOTE
After reassembly, pump the brake control lever until the pads
are against the brake disc.
EN - 33