Start-Up Instructions Storm; Timer Features Storm - Pentair Fleck 5800 SXT Betriebsanleitung

4 - START-UP INSTRUCTIONS STORM

The water softener should be installed with the inlet, outlet, and
drain connections made in accordance with the manufacturer's
recommendations, and to meet applicable plumbing codes.
1. Program the valve control according to instructions shown
in this manual.
2. Start an immediate regeneration by holding the Extra Cycle
button for 5 seconds. Position the valve to backwash.
Ensure the drain line flow remains steady for 10 minutes or
until the water runs clear.
3. Position the valve to the brine / slow rinse position. Ensure
the unit is drawing water from the brine tank (this step may
need to be repeated).
4. Position the valve to the rapid rinse position. Check the
drain line flow, and run for 5 minutes or until the water runs
clear.
5. Position the valve to the start of the brine tank fill cycle.
Ensure water goes into the brine tank at the desired rate.
The brine valve drive cam will hold the valve in this position
to fill the brine tank for the first regeneration.
6. Replace control cover.
7. Put salt in the brine tank.
NOTE: Do not use granulated or rock salt.
4 • MR12 Fleck 5800 Storm & Typhoon Downflow/Upflow

5 - TIMER FEATURES STORM

Program Icon
Program
Display
Icon
Display
Position
Position
Flow
Flow
Indicator
MODE
Indicator
Mode
Mode
Button
Button
Features of the Storm:
• Power backup that continues to keep time and the Figure 2
passage of days for a minimum of 12 hours in the event
of power failure. During a power outage, the control goes
into a power-saving mode. It does not monitor water
usage during a power failure, but it does store the volume
remaining at the time of power failure.
• Day of the week reserve calculates a reserve for each
day based on the past 4 weeks.
• The Flow Indicator flashes when outlet flow is detected.
• The Service Icon flashes if a regeneration cycle has been
queued.
• A Regeneration can be triggered immediately by pressing
the Extra Cycle button for five seconds.
• During a regeneration, the display will show the cycle
number followed by the time remaining in that cycle
• During regeneration, the user can force the control to
advance to the next cycle step immediately by pressing
the extra cycle button.
Cycle
Setting the Time of Day
1. Press and hold either the Up or Down buttons until the Time
of Day icon appears.
2. Adjust the displayed time with the Up and Down buttons.
3. When the desired time is set, press the Extra Cycle button
to resume normal operation. The unit will also return to
normal operation after 5 seconds if no buttons are pressed.
Queueing a Regeneration
1. Press the Extra Cycle button. The service icon will flash to
indicate that a regeneration is queued.
2. To cancel a queued regeneration, press the Extra Cycle
button.
Regenerating Immediately
Press and hold the Extra Cycle button for five seconds.
Clock
Clock
R
12:00
R
Extra Cycle
Button
Figure 2
Time
Remaining
Figure 3
PM
Figure 4
Extra Cycle
Button