Diagnostic Programming Mode Storm - Pentair Fleck 5800 SXT Betriebsanleitung

10 - DIAGNOSTIC PROGRAMMING
MODE STORM
Demand - US Units
Diagnostic
Code
H1 Displays the days since last regeneration, 0-30.
H2 Displays the current flow rate, gallons per minute.
H3 Displays the current day of week, 1-7.
H4 Displays the total volume of water treated by the unit
for the current day in gallons.
H5 Displays the total volume of water used since the last
H6 Displays the software version. Version number of
software. D = Downflow U = Upflow
A1 Displays the average water usage for day 1, in
A2 Displays the average water usage for day 2, in
A3 Displays the average water usage for day 3, in
A4 Displays the average water usage for day 4, in
A5 Displays the average water usage for day 5, in
A6 Displays the average water usage for day 6, in
A7 Displays the average water usage for day 7, in
Demand - Metric Units
Diagnostic
Code
H1 Displays the days since last regeneration, 0-30.
H2 Displays the current flow rate, liters per minute.
H3 Displays the current day of week.
H4 Displays the total volume of water treated by the unit
for the current day, in cubic meters.
H5 Displays the total volume of water used since the last
regeneration, in cubic meters.
H6 Displays the software version. Version number of
software. D = Downflow U = Upflow
A1 Displays the average water usage for day 1, in cubic
A2 Displays the average water usage for day 2, in cubic
A3 Displays the average water usage for day 3, in cubic
A4 Displays the average water usage for day 4, in cubic
A5 Displays the average water usage for day 5, in cubic
A6 Displays the average water usage for day 6, in cubic
A7 Displays the average water usage for day 7, in cubic
10 • MR12 Fleck 5800 Storm & Typhoon Downflow/Upflow
Description
regeneration in gallons.
gallons.
gallons.
gallons.
gallons.
gallons.
gallons.
gallons.
Description
meters.
meters.
meters.
meters.
meters.
meters.
meters.
Time Clock
Diagnostic
Code
H1 Displays the days since last regeneration, 1-7.
H6 Displays the software version. Version number of
software. D = Downflow U= Upflow
Time of
Day
NOTE: The Engilsh timer will be in gallons. The Metric
Time of
timer will be in liters for all flow rates.
Backwash
Backwash
Length
Diagnostic Programming Mode Steps
MODE
Mode Up Arrow
Button
Figure 12
1. To enter the Diagnostic Programming Mode, press and hold
the Mode button and the Up arrow.
2. The display will show the first diagnostic. Press the Up
arrow to view the value.
3. Press the Mode button twice to move to the next diagnostic.
4. Press the Up arrow to view the value. Continue in this
manner until you have viewed all the diagnostics. The table
above shows all the diagnostics.
5. To exit Diagnostic Programming Mode, hold the Extra Cycle
button for one minute. It will also exit after 30 seconds if no
button is pushed.
Description
Filter
Capacity
PM
Capacity
Remaining
Resin
Down Arrow Extra Cycle
Button