Werbung
Verfügbare Sprachen
Verfügbare Sprachen
[3]
Fold out the rods (narrow pole) on part C.
③
①
②
Stopper
1 Release the quick release levers at each base of the rod.
2 Slide the quick release to the stopper position.
3 Move the rods outwards horizontally.
[4]
Lock the rod ends of C onto A and B.
C
B
C
④
1 Open the quick release levers for A and B.
2 Insert the ends of the rods as far as they will go.
3 Lock the quick release levers for A and B to stabilize the rod ends.
4 Lock the quick release for part C to stabilize the bases of the rods.
Before doing step 4, make sure that the bases of the rods are not
misaligned away from the stopper positions.
[5]
Attach part D (the tier) as shown in the illustration, and
turn the handles to lock.
①
D
②
If you fail to tighten the handles, your instrument may fall off the tier
and become damaged, or you may become injured. For this reason,
be sure to stabilize the tier by firmly tightening the handles until they
cannot move any more.
When the handle interferes with the instrument:
②
Grab the handle as shown in the illustration,
and pull out the handle while pressing in
the center part to rotate the handle part only.
Adjust the handle angle so that it does not
interfere with the instrument.
①
C
Rod
Quick release
①
③
②
A
Handle
①
[6]
Place the E parts (keyboard holders) onto part D, and
rotate them accordingly so that they snap onto part D.
②
E
D
①
1 Place the E parts at an angle opposed to the pipes of part D.
2 Rotate the E parts in the direction of the arrow, and snap them
onto the pipes.
Place the E parts towards the outside as much as possible, in order to
distribute the weight of the instrument, and to reduce the amount of
vibration and swaying when playing.
Using the Keyboard Holders
Front
Back
Keyboard stopper
You're now finished assembling the
stand. Place the instrument on the stand,
aligned with the keyboard stoppers.
Precautions After Assembly
- Adjusting the height and angle
Take your instrument off of the stand before adjusting the stand's
height and angle. Failure to do so may result in your hand getting
pinched, or the stand may fall over and injure you.
Adjusting the height:
1 Loosen the height adjustment knob.
2 Slide the tier up and down, and turn the height adjustment knob
to lock the tier in place.
Adjusting the angle:
1 Loosen the handles on the inside of the tier to adjust the
angle.
2 Once you have decided on the tier angle, firmly close the handles
to lock the tier in place.
- What to do when the quick release levers or height
adjustment knobs are loose
After you assemble the stand, the quick release levers and height
adjustment knobs may gradually become loose over time. Periodically
check these parts to make sure that they are not loose. If the stand
seems to vibrate a lot when you are playing, retighten the quick release
adjusting nuts and the height adjustment knobs.
When carrying the stand
This stand can easily be disassembled without changing the height
adjustments. Disassemble the stand using the steps you use to assemble
the stand in reverse order.
You do not need to remove the holders
in order to remove the tier. With the
holders still attached to the pipes,
loosen the handles and disassemble as
shown in the illustration. You will be
able to quickly reassemble the stand
as it was before.
②
E
T he attachment position of the
keyboard holders can be moved
forward or backward, to match the size
of the instrument that you are using.
Position the keyboard stoppers in front
of you, in a configuration which makes
the instrument easy to play.
Handle
Holder
3
Werbung
