Sequenz Standard-L Bedienungsanleitung Seite 2

Precautions
Location
Using the unit in the following locations can result in a malfunction.
• In direct sunlight
• Locations of extreme temperature or humidity
• Excessively dusty or dirty locations
• Locations of excessive vibration
Handling
To avoid breakage, do not apply excessive force to the switches or
controls.
Care
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do
not use liquid cleaners such as benzene or thinner, or cleaning
compounds or flammable polishes.
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If
liquid gets into the equipment, it could cause a breakdown, fire,
or electrical shock. Be careful not to let metal objects get into the
equipment.
IMPORTANT NOTICE TO CONSUMERS
This product has been manufactured according to strict
specifications and voltage requirements that are applicable in
the country in which it is intended that this product should be
used. If you have purchased this product via the internet, through
mail order, and/or via a telephone sale, you must verify that this
product is intended to be used in the country in which you reside.
WARNING: Use of this product in any country other than that for
which it is intended could be dangerous and could invalidate the
manufacturer's or distributor's warranty.
Please also retain your receipt as proof of purchase otherwise
your product may be disqualified from the manufacturer's or
distributor's warranty.
* All product names and company names are the trademarks or
registered trademarks of their respective owners.
Caution During Assembly
In order to safely assemble the stand, please observe the following
points:
• Assembly must be carried out by at least two people.
• Be careful not to pinch your fingers during assembly.
List of Parts
Please check the illustration below carefully, and make sure you have all
the parts before assembly. Assemble the parts in a flat, stable location.
D
E
B
A: Right leg
B: Left leg
C: Side pipes
Keyboard Holders
To take off the keyboard holders, turn the keyboard holders while
pulling them off the pipes on the tier. To make the stand more compact
when carrying it around, attach the keyboard holders to the tier by
following the steps in reverse order.
2
E
C
A
D: Tier (keyboard rack)
E: Keyboard holders
Using the Quick Release
In order to lock the quick release with enough strength, you should feel
a certain amount of resistance when locking the lever.
See the illustration when adjusting the lever.
③
①
②
Using the Height Adjustment Knob
Follow the steps in the illustration to tighten the height adjustment
knob.
Height
adjustment
knob
②
①
Knurled nut
Steps for Assembly
[1] Lay out parts A and B as shown in the diagram, and
hold the bottom side pipe in place.
①
②
Push the bottom side arm firmly into the locking mechanism.
[2] Insert both ends of C into parts A and B.
②
C
B
1 Position part C so that the quick release lever (c) faces the rear
side.
2 Open the quick release levers for A and B.
3 Insert the ends of part C as far as they will go.
4 Lock the quick release levers for A and B to stabilize part C.
1 Unlock the lever.
2 Turn the adjusting nut in the
direction of the arrow, and tighten
it until you feel a small amount of
resistance.
3 Fold the lever down 180° to lock it.
If the clamping force does not seem
tight enough, open the lever again, and
tighten the adjusting nut.
1 Turn the knurled nut in the
direction of the arrow to tighten,
while the height adjustment knob
is loose.
2 Turn the height adjustment knob in
the direction of the arrow to secure
it to the pipe.
Firmly tighten the knob until it is
entirely snug so that it is secure.
Correct
Incorrect
④
③
A
C
Lever (c)
①