Zhermack DOUBLEMIX Handbuch Für Gebrauch Und Wartung Seite 118

WARNING
9.1
Should any of the anomalies described below occur try setting the situation
right, as far as is permissible, by following the instructions contained in this
handbook. Should the problem persist contact your Authorised Servicing Centre.
PROBLEMS, CAUSES AND REMEDIES
9.2
p
roblem
The material does
not exit from the
mixing tip when the
pump start button is
pressed.
The machine does
not work.
9.2.1 Cleaning the mixing block
Rotate the tap upwards. Undo the
plate fixing screws under the tap
using the Allen key (supplied).
118 of 188
CHAPTER 9: TROUBLESHOOTING
C
ause
1. The tap is clogged.
2. The container is at
minimum.
1. Main power cable
malfunction.
2. The pump does not work.
3. The fuse has burnt out.
Using a pointed implement and
paper, clean the areas indicated
by the arrows with care.
MAINTENANCE AND USE MANUAL
EN
r
emedy
1. Contact an Authorised Assistance
Centre.
2. Replace the container.
1- 2. Contact an Authorised Assistance
Centre.
3. Contact an Authorised Assistance
Centre to have it replaced with one
having the same characteristics.
DOUBlemix
Before screwing in the plate
it is necessary to extrude a
small amount of material until
homogeneity between the two
materials is obtained.
DOUBLEMIX