Motion CM-04 Gebrauchsanweisung Seite 18

16 Reset favourite position
Centre
17 Deactivate direct control
When pressing the up or down button on the remote control, the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be deactivated. Now, the blind only directly moves to its end
positions when the up or down button is held longer than two seconds.
Press the program button on the motor to activate
17.1
program mode. The blind starts stepping.
Hold the program button until the blind stops stepping (approximately 5 seconds)
17.2
to deactivate or reactivate direct control.
M OT I ON C M- 0 4 T U B U L AR M O TO R
Move the blind to a desired favourite position.
16.1
Press the program button on the motor to activate
16.2
program mode. The blind starts stepping.
Hold the centre button to save this favourite position. The blind shortly stops
16.3
stepping, indicating the favourite position has been saved succesfully.
Press the program button on the motor to deactivate
16.4
program mode. The blind stops stepping.