What If There Are Problems - Beurer BY 33 Gebrauchsanweisung

9. What if there are problems?

Faults
Power LED does
not light up after
switch-on.
An acoustic signal
sounds from the
parent unit.
The signal is weak,
the connection
keeps breaking up
or there is interfe-
rence.
No acoustic signal
sounds from the
parent unit.
A device switches
itself off.
Actions
Check whether
the relevant adapter plug is properly plugged in,
The batteries are full or the rechargeable battery
needs charging or is damaged (parent unit).
Check whether
the maximum range has been exceeded
the power supply unit for the baby unit is correctly
connected
the baby unit is switched on
The batteries are full or the rechargeable battery
needs charging or is damaged (parent unit).
If another technical device such as a microwave is in
the area between the parent and baby units, remove
the device or switch it off.
Check whether other factors, such as trees etc.
are in the path of the two devices, and change the
position of the devices until the parent unit signals a
connection.
Check whether the baby and parent units are inside
the respective receiving range.
Adjust the volume on the parent unit.
Replace the batteries or recharge the battery (parent
unit).
28