Switching On/Off; Operating Instructions; Cleaning/Maintenance; Cleaning & Maintenance - Parkside PAS 500 B1 Originalbetriebsanleitung

GB IE
4. Plug the suction tube (12) onto
the rigid end piece of the suc-
tion hose (11).

Switching on/off

Connect the mains plug.
The equipment is fitted with a
safety stop, which allows operation
only with the pleated filter and wire
filter basket installed correctly.
Switching On:
On/Off Switch (see
Switching Off:
On/Off Switch (see

Operating Instructions

The vacuuming of glowing em-
bers and of materials that are
combustible, explosive or harm-
ful to health is prohibited.
There is a risk of injury!
• Place the equipment on a level sur-
face that is not heat sensitive.
• Always use the suction tube for vacu-
uming. Hold the suction tube at a dis-
tance of approx. 1 cm above the ash.
• Vacuum only cooled ash at less than
40°C.
• When vacuuming, keep checking the
metal container and suction hose for
rises in temperature.
• In the event of a rise in temperature,
switch off the equipment and discon-
nect at the plug. Place the equipment
outside and monitor it as it cools.
• During breaks, you can place the suc-
tion hose (
8
6) In position "I"
6) In position "0"
12) in the accessory
holder ( 2) on the container lid.
• Always use the carry handle (
transporting the equipment.
• The metal container may be filled to
no more than half, so the pleated filter
always remains clear.
• Empty the container outside in order
to avoid mess (see "cleaning/mainte-
nance").
• Clean the pleated filter (
"cleaning/maintenance") if the suction
performance deterio rates or when the
inspection window blockage indicator
( 3) on the container lid turns red.

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Never hose the appliance down
with water. Never use aggres-
sive cleaning agents or sol-
vents. This could damage the
appliance.

General Cleaning Work

Clean the equipment after each use:
• Carry out cleaning outside in order to
avoid mess.
• Take off the container lid (
empty the metal container (
Clean the metal container with water
and allow it to dry.
• Clean the wire filter basket and the
pleated filter (see below).
Cleaning the Wire Filter Bas-
ket and Pleated Filter
Replace the pleated filter if it is
worn, damaged or heavily soiled
(see "replacement parts").
9) for
13) (see
5) and
10).