Carrier 80HMA-M03 Installationsanleitung Seite 42

Diagnostic
Error code
User mode is HEAT, all zones are not
56 allowed to work in HEAT. Or user
master mode is not allowed
User mode is COOL, all zones are not
57 allowed to work in COOL. Or user
master mode is not allowed
Communication from not existing
58
addresses
59 Two OR More Masters
60 More than 1 pool kit
61 Product_ID Mismatch
62 User Interface in zone definition error
Error on associated User Interface
63 (master User Interface or additional
User Interface)
64 Alarm severity 1
65 Alarm severity 2
Lost communication on control input
66
on master board
Configuration
70 Mode mismatch
Mode mismatch
71 Mode mismatch in pool kit
72 Mode mismatch in pool kit
73 Water in tank termperature
Temperature/humidity sensor of user
74
interface
75 Leaving water temperature sensor
76 Pressure Switch
77 Safety input
78 Communication Master – Slave
79 Commnication with User Interface
30 80HMA
Item
Carrier Fixed Speed
Carrier Fixed Speed
Slave Boards
Multi zone Par. 107=1
System configured
Multi zone System
configured to use
System configured
System type
User mode is HEAT, all zones
Any are not allowed to work in
HEAT (Par. 108.2=0)
User mode is COOL, all zones
Any are not allowed to work in
COOL (Par. 108.1=0)
Communication from a not
Any
know address
Communication from more
Any
than 1 Master
Communication from more
Any
than 1 pool board
Addressed device is not within
Any
valid range
Two User Interfaces associate
Single zone
to master board at zone 1
Diagnostic active on master
any User Interface or additional
User Interface
Communicated by heat pump
or alarm severity 1 input is
ACTIVE
Communicated by heat pump
or alarm severity 2 input is
ACTIVE
No communication within
Master
24hr on input set as 12
Board has slave address and is
Single zone
not a pool kit
Master mode is COOL.
Multi zone Cool prevented in that zone
(Par. 108.1=0)
Master mode is HEAT
Multi zone
(Par. 108.2=0)
Slave user mode is COOL.
Any; pool kit Cool prevented in that zone
(Par. 108.1=0)
Slave user mode is HEAT
Any; pool kit HEAT prevented in that zone
(Par. 108.2=0)
Value out of range and sensor
Multi zone
is mapped
Value out of range
Multi zone
Value out of range
to use
Pressure is too low. Contact
is ACTIVE
Multi zone
SAFETY input is ACTIVE
to use
Communication lost with
Multi zone
Mater board
Communication lost with User
Multi zone
Interfaces
Failure when Type
B;D
B;D
B;D
B;D
B;D
B;D
B;D
B;D
B
B
A
A
B
A
B
B
B
A
A
B
B
B