The Sauna Heater's Water Tank - Helo FONDA DUO Produkthandbuch

Operating and installation instructions Fonda duo
Setting of the pre-selection time:
The pre-selection time can be set by selecting the fourth menu on the starting page.
There are two different pre-selection functions:
Normal pre-selection (Timer) where the switching on of the heater can be set
within 24 hours, and the calendar function (Calendar) where it is possible to
control the switching on of the heater according to a weekly schedule.
Settings for control:
In the fifth menu on the front page, you can manually access the settings for the control
unit that include, for instance, Sauna settings, General settings and Service settings. The
Service settings have been protected with a PIN code (124) that prevents unintentional
changes to important settings.
2.9

The sauna heater's water tank

Filling the tank
Fill the sauna heater's water tank using the steam nozzle. The water tank holds about five litres of water
If the tank is empty when the sauna heater starts, the heater emits three short beeps. A drop of water indicating the
steam function will flash at the same time in the control device.
The sauna heater also emits a beep if the tank is full after it has been filled. The sauna heater must always be in
standby mode (main power switch in position I) when you fill the water tank. This is to prevent the tank overfilling.
NOTE!
Do not pour fragrance oil or other chemicals (except lime remover) in the water tank.
Use the removable aroma cup at the front of the sauna heater for this purpose.
Water refill
9
Calendar setting
Calendar
Timer
Settings
Sauna
General
Service
OK