Caution Utility Services; Original Accessories / Attachments; Have You Understood Everything; Before First Use - Parkside PSBM 850 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Before first use
Always make sure that nobody is placed in
any danger and that there are no inflammable
materials near the working area.
WarNING! HaZarDOUS DUSTS!
Working with harmful / poisonous dusts presents
a danger to health for the tool operator and
any persons in the vicinity.
Wear safety glasses and a dust
protection mask!
J
Avoid drilling paints containing lead or other
substances hazardous to health.
J
Do not drill or abrade materials containing
asbestos. Asbestos is a known carcinogen.
J
Do not drill moist materials or damp surfaces,
J
When working always hold the device securely
with both hands.
J
If the inserted tool jams, switch off the electrical
power tool immediately. Be prepared for high
reaction torques as they may cause kickback.
J
Always keep the device clean, dry and free of
oil or grease.

Caution utility services!

Q
m DaNGEr! Ensure that you do not strike
electrical cables, gas or water pipes when
you are working with the electrical pow-
er tool. Check a wall using a suitable detector
before you drill or cut slots.
Original accessories /
Q
attachments
Use only the accessories and attachments
detailed in the operating instructions.
The use of inserted tools or accessories other than
those recommended in the operating instructions
could lead to you suffering an injury.
Have you understood
Q
everything?
Once you have made yourself familiar with this
general safety advice for electrical power tools, and
with the help of the device's operating instructions
10 GB
you now know about all the functions of and how
to handle your electrical power tool, you are finally
in a position to start work. Observing the manufac-
turer's instructions and advice will maximise your
safety while working with the device.

Before first use

Q

attaching the auxiliary handle

Q
For safety reasons this tool must always be used
with the auxiliary handle
j
Place the auxiliary handle
collar and bring it round into the desired position.
Tighten the auxiliary handle
j
If necessary fit the depth stop

Inserting a tool into the chuck

Q
WarNING! DaNGEr OF INJUrY!
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.

Opening the chuck

Q
Note: The directions of rotation are given relative
to the device being held by you in the working
position / „drill chuck pointing away from you".
Your 2-speed hammer-action drill has a fully auto-
matic spindle lock
sleeve chuck "Made in Germany" by
The quick-release chuck
drills or other tools without using a special key etc.
The drive chain is locked when the motor comes to
standstill so that the quick-release chuck
opened by turning it

Tightening the chuck

Q
After you have selected and inserted the tool and
fixed the inserted tool in place by the turning the
in place.
7
on the spindle
7
in position.
7
.
9
and is fitted with a single
.
allows you to exchange
8
can be
8
.